A single leak in the brake lines can cause terrible accidents. This is why, when you are a vehicle owner, you may always have concerns about your brake lines. Most of the time, it is caused by the wrong inverted flare fittings in the brake systems. Thus, it is important to know about flare fittings and their installation processes.
This post will tell you about the detailed process of inverted flare fittings at the installation time.
You Must Use Top Quality Fittings:
You must use high-quality inverted flare fittings that are suitable for brake lines. Underling fittings are not that capable of providing a strong knot, which causes leakage in the brake systems.
You Must Make the Surfaces:
Before fittings installation, make sure about the matting surfaces. They must be clean and free of debris. Any minor contaminants can damage the integrity seal while installing.
You Must Correct Flare Angle:
At the time of flaring the brake line end, make sure the angles match the fitting specifications that you use. In the cases of inverted flare fittings, the angles are mostly 45 degrees, with very minor variations. Thus, check for a correct flare angle to seal properly with your brake line flaring tool.
You Must Do Proper Tightening:
Make the flare fitting as tight and accurately as much as you can, but don’t over-force. Use a flare nut here to tighten the overall fitting, and of course, don’t forget the recommended torque specification. Over-tightening may cause leakage or sudden outbursts of the fitting.
You Must Check for Leaks:
After the tightening process, check for leaks. Remember, you must carefully check for a single sign of a leak, otherwise it may damage the whole installation system. If you find any leakage sign or a nut is not as tight as you require, replace it.
Regular Maintenance:
Check the overall flare fitting brake line system from time to time. If you find anything abnormal in the fittings after some weeks, do change it. If you are unable to find the problems by yourself, call an expert to figure it out.
The conclusion is, that inverted flare fittings are important when it comes to brake lines. These fittings provide a secure notch to brake systems that cause proper vehicle running. So, choose a Brake Line Tubing kit that is accurate to your vehicle brake line. The Stop Shop is a good destination to have it.